Piusi K900 - Configuration of the Units of Measurement

47/124
47 /56
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
Translated from Italian
9.1 CONFIGURATION OF THE UNITS OF MEASUREMENT
The METER feature a menu with which the user can select the main measurement unit, Quarts (Qts), Pints (Pts),
Litres (Lit), Gallons (Gal); he combination of the unit of measurement of the Partial register and that of the
Totals is predefined according to the following table:
Combination no.
Unit of Measurement
Partial Register
Unit of Measurement
Totals Register
1 Litres (L) Litres (L)
2 Gallons (Gal) Gallons (Gal)
3 Quarts (Qts) Gallons (Gal)
4 Pints (Pts) Gallons (Gal)
To choose between the 4 available combinations:
1 Wait for the METER to go to Standby
2
CAL
RESET
+
Then press the CAL and RESET keys together. Keep these pressed until the word “UNIT” ap-
pears on the screen together with the unit of measurement set at that time (in this example
Litres / Litres )
3
RESET
Every short press of the RESET key, the various combinations of the units of measurements are
scrolled as shown below:
Gal
Qts
Pts
Gal
RESET
RESET
RESET
4
CALCAL
CAL
By pressing the CAL key at length, the new settings will be stored, the METER will pass
through the start cycle and will then be ready to dispense in the set units.
ATTENTION The Reset Total and Total registers will be automatically changed to the new
unit of measurement.
NO new calibration is required aer changing the Unit of Measurement.