Need help?Do you have a question about the Piusi K24 and is the answer not in the manual?
General| Repeatability | 0.2% |
|---|---|
| Maximum Pressure | 10 bar |
| Display | LCD |
| Max. operating pressure | 10 bar |
| Bursting pressure | 30 bar |
| Model | K24 |
| Manufacturer | Piusi |
| Connection | 1" BSP |
| Fluids | Diesel |
| Type | Flow Meter |
General warnings, symbols used, and instructions for manual preservation and reproduction rights.
Critical warnings for mains checks, maintenance, fire, and explosion hazards.
Details hazards associated with equipment misuse, including injury and death.
Advises on handling hazardous fluids and potential skin irritation.
Provides first aid rules and prohibits smoking and open flames during operation.
Outlines general safety rules and requirements for personal protective equipment.
Describes the packaging contents and label information.
Instructions for opening and checking package contents, with warnings.
Describes product versions, groups, and flow rate specifications.
Lists compatible liquids based on meter body material and turbine system.
Describes displayed registers, status indicators, and unit of measurement.
Covers meter positioning for display visibility and an installation warning.
Explains the functions of the RESET and CAL buttons and provides a legend.
Details the two available operating modes: Normal Mode and Flow Rate Mode.
Provides a wiring diagram for the Pulser installation.
Covers meter installation flexibility and provides an installation warning.
Introduces daily tasks like resetting total registers and the standby state.
Details dispensing operations in the standard Normal Mode, including warnings.
Explains how to reset the partial register when the meter is in standby.
Details the procedure for resetting the resettable total register.
Details dispensing with simultaneous display of partial and flow rate.
Provides the procedure for entering the Flow Rate Mode display.
Clarifies flow rate measurement units and display stability.
Explains how to reset the partial register when in Flow Rate Mode.
Explains when on-the-spot calibration might be required for extreme conditions.
Defines the calibration factor (K Factor) used to transform pulses into fluid units.
Details the factory-set default factor and the user-customized factor.
Lists reasons for calibration: viewing, restoring, or changing the factor.
Introduces the two procedures for changing the Calibration Factor.
Notes that K24 cannot be used for normal dispensing in calibration mode.
Introduces in-field calibration using a graduated sample container.
Lists crucial points for correct K24 calibration during this procedure.
Step-by-step guide for performing in-field calibration.
Provides an example calculation for modifying the calibration factor based on error.
Step-by-step guide for directly modifying the calibration factor (K Factor).
Explains how to select the main measurement unit (Litres, Gallons, Quarts, Pints).
Provides step-by-step instructions for changing unit of measurement combinations.
States that no new calibration is required after changing the Unit of Measurement.
Warns about battery replacement position and describes low battery alarms.
Provides a step-by-step guide for replacing the meter's batteries.
Details how to clean the K24 and when turbine replacement may be needed.
Advises on proper disposal of old batteries and avoiding compressed air on the turbine.
Provides detailed steps for replacing the front face of the K24 meter.
Identifies common problems, their causes, and remedial actions.
General introduction to proper disposal of system parts.
Groups disposal for packaging, metal, electronic, and miscellaneous parts.
Details EU regulations for waste disposal of electronic equipment.
Details the turbine measurement system, resolution, and flow rate ranges.
Covers operating pressure, temperature, humidity, and resistance parameters.
Lists flow resistance, viscosity, accuracy, and reproducibility.
Details screen, power supply, battery life, weight, protection, and pulser specs.
Shows an exploded view and overall dimensions for the METER version.
Shows an exploded view and overall dimensions for the PULSER version.
To Next Page
