?
4 /20
Use, maintenance and calibration
M0171G
3 SAFETY INSTRUCTIONS
3.1 SAFETY WARNINGS
Mains - preliminary
checks before
installation
ATTENTION
You must avoid any contact between the electrical power supply and the
fluid that needs to be FILTERED.
Maintenance
control
Before any checks or maintenance work are carried out, disconnect the power
source.
For your safety,
review the
major ATTEN-
TIONs and
cautions below
before operat-
ing your meter
When metering flammable liquids, observe precautions against fire or explosion
When handling hazardous liquids, always follow the liquid manifacturer’s safety
precautions
Always dispose of used cleaning solvents in a safe manner according to the sol-
vent manifacturer’s instructions.
During meter removal, liquid may spill. Follow the liquid manifacturer’s safety pre-
cautions to clean up minor spills
Do not blow compressed air through the meter
Do not allow liquids to dry inside the meter
FIRE AND
EXPLOSION
Connect the metal parts of the device to earth
Stop operation immediately if static sparking occurs or if you feel a shock. Do not use
equipment until you identify and correct the problem.
Keep a working fire extinguisher in the work area.
EQUIPMENT
MISUSE
Misuse can
cause death or
serious injury
!
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
Do not leave the work area while equipment is energized or under pressure.
Turn off all equipment when equipment is not in use.
Do not alter or modify equipment. Alterations or modifications may void agency
approvals and create safety hazards.
Route hoses and cables away from traffic areas, sharp edges, moving parts, and
hot surfaces.
Do not kink or over bend hoses or use hoses to pull equipment.
Keep children and animals away from work area.
Comply with all applicable safety regulations.
Toxic Fluid or
Fumes Hazard
Read MSDS’s to know the specific hazards of the fluids you are using.
Store hazardous fluid in approved containers, and dispose of it according to ap-
plicable guidelines.
Prolonged contact with the treated product may cause skin irritation: always
wear protective gloves during dispensing.
To Next Page
Loading...
Need help?
General
