Quick Installation Guide
- 13 - PLANET Technology Corp.2024
The user can now enter commands to manage the Industrial
Managed Switch. For a detailed description of the commands,
please refer to the following chapters.
1. For security reason, please change and memorize
the new password after this first setup.
2. Only accept command in lowercase letter under
console interface.
The following console screen is based on the firmware
version of February of 2024 or after.
Username: admin
Password: sw + the last 6 characters of the MAC ID in lowercase
Find the MAC ID on your device label. The default password is “sw”
followed by the last six lowercase characters of the MAC ID.
Figure: MAC ID Label
Enter the default username and password, then set a new password
according to the rule-based prompt and confirm it.
To Next Page
Loading...
