Planet MGSW-28240F - Page 11

11
The previous command would apply the following settings for the Managed
Metro Switch.
IPAddress:192.168.1.100
SubnetMask:255.255.255.0
4.Repeatstep 1tocheckiftheIPaddresshaschanged.
If the IP is successfully congured, the Managed Metro Switch will apply the
new IP address setting immediately. You can access the Web interface of the
ManagedMetroSwitchthroughthenewIPaddress.
4.3 StoringCurrentSwitchConguration
In the Managed Metro Switch, the running conguration sequence running-
congcan besaved from the RAMto FLASHby “copy”command, so thatthe
running conguration sequence becomes the start-up conguration le, which
iscalledcongurationsave.
Atthe“#”prompt,enterthefollowingcommandandpress<Enter>.
# copy running-cong startup-cong
Figure 4-8: Saving Current Conguration Command Screen
If you are not familiar with the console command or the related
parameter, enter “help” anytime in console to get the help
description.