Need help?Do you have a question about the Planet SGSW-4802 and is the answer not in the manual?
Presents the technical specifications of the SGSW-4802, including ports, throughput, and environmental requirements.
Describes the front panel components, including Ethernet ports, expansion slots, console port, and LED indicators.
Details the procedure for configuring the switch's IP address via the console interface.
Explains how to access and configure the switch using a web browser.
Allows configuration of individual switch ports, including speed, duplex, and state.
Details how to configure Virtual LANs (VLANs) for traffic isolation and grouping.
Covers configuration of the Spanning Tree Protocol (STP) for network loop prevention.
Covers configuring port security by assigning MAC addresses to specific ports.
Allows configuration of basic switch information, IP address, subnet mask, and default gateway.
Guides on downloading and upgrading the switch's firmware to the latest version.
Allows saving current configuration, backing up, restoring, or resetting the switch to factory defaults.
Steps to log in to the switch via the console interface using default or custom credentials.
Commands for managing system parameters like IP, name, contact, location, and password.
Commands for displaying and configuring port status, speed, duplex, security, and VLAN settings.
Commands for managing VLANs, including showing, building, deleting, and setting VLAN priorities.
To Next Page
General