64
4.2.5.2 trunk set <g0|g1> <port1> [port2] [port3] [port4]
These commands allow assigning maximum up to 4 ports as trunk port from port 1-24 and port 26-48.
The screen in Figure 4-45 appears.
Figure 4-45: Trunk group setting Screen
4.2.6. stp--STP Management Commands
These commands allow configuring the STP function on SGSW-4802. The screen in Figure 4-46
appears.
Figure 4-46: Disable / enable STP Screen
4.2.6.1 stp [on|off]
This command allows disable (off) or enable (on) the STP function. The screen in Figure 4-47 ap-
pears.
To Next Page
Loading...
Need help?
General