Planet SGSW-4802 - IGMP Management Commands

71
Figure 4-62: Stack on Screen
!
NOTE
Please note when choose “Master” from “Stacking State”. It allows user to
assign this
Switch as
Master device in this stack group. Then the rest of the Switches should be slave
device.
4.2.9 igmp--IGMP Management Commands
These commands allow configuring the IGMP Parameters. The screen in Figure 4-63 appears.
Figure 4-63: IGMP Screen
4.2.9.1 igmp show
This command allows to viewing the current status of IGMP function. The screen in Figure 4-64 ap-
pears.