Planet POE-1200G Quick Installation Guide

10
4. Recovering Back to Default Conguration
 IP Address has been changed or password has been forgotten
To reset the IP address to the default IP address “192.168.0.100” and the user
password to factory default mode (default password is sw + the last 6 characters of
the MAC ID in lowercase), press the hardware-based reset button on the front panel
for about 10 seconds. After the device is rebooted, you can log in the management
Web interface within the same subnet of 192.168.0.xxx.
Management
Reset
PoE
FAN1 FAN2
Alert
12-Port Gigabit 802.3at PoE
+
Managed Injector Hub
POE-1200G
LNK/ACT
SYS PWR
Reset Button
Figure 4-1: POE-1200G Reset Button
PoE-in-Use
Management
Reset
PoE
FAN1 FAN2
Alert
1 2
1
2
LNK/ACT
SYS PWR
POE-2400G
Reset Button
Figure 4-2: POE-2400G Reset Button
Management
Reset
PoE
FAN1 FAN2
Alert
12-Port Gigabit 802.3at PoE
+
Managed Injector Hub
HPOE-1200G
LNK/ACT
SYS PWR
Reset Button
Figure 4-3: HPOE-1200G Reset Button

Planet POE-1200G Specifications

General

Brand	Planet
Model	POE-1200G
Category	Switch
Language	English