1-4
English
4.Connect with IEEE 802.3af devices. Base on IEEE 802.3af standard,
the POE-151/POE-152 can directly connect with any IEEE 802.3af
end-nodes like wireless access point, VoIP phones and IPcamera that
support IEEE 802.3af Power over Ethernet interface.
ForPOE-161,baseonIEEE802.3atstandard,thePOE-161
can directly connect with any IEEE 802.3at end-nodes such
as PTZ (Pan, Tilt & Zoom) IP camera, Speed Dome, high
power consumption wireless LAN access point that support
IEEE 802.3at Power over Ethernet port.
Ethernet Switch
100 meters
PoE IP Camera
POE-151/152
PoE Injector
Power
Power Line (DC)
100Base-TX UTP
100Base-TX UTP with PoE
PoE
DC
Power Line (AC)
AC
PoE
Power
Data
Data
DC
PoE
PWR
Ethernet+DC
PoE-IEEE 802.3af
Ready
Power in-use
48V DC
Ethernet
AC
Figure 3: Connection to IEEE 802.3af Device
5. Once POE-151/POE-152 detects the existence of an IEEE 802.3af
device, the LED indicator will be steady ON to shows it is providing
power. The same to POE-161 that detects the existence of an IEEE
802.3at / af device.
If the connected device is not fully complying with IEEE
802.3af standard, the LED indicator of POE-151/POE-152
will not be steady on.
1. Since the POE-161 PoE port supports 56V DC PoE
power output, please check and assure the Powered
Device (PD) acceptable DC power range is from 52 to
56V DC. Otherwise, it will damage the Powered Device
(PD).
2. If the connected device is not fully complying with IEEE
802.3at / af Power over Ethernet, the LED indicator of
POE-161 will not be steady on.
To Next Page
Loading...
Need help?
General
