Planet WGS-5225-8P2S - Storing The Current Switch Configuration

17
CongurationoftheIPAddress
3.At the “#” prompt, enter the following command and press <Enter> as
shown in following.
WGS-5225-8P2SV# congure terminal
WGS-5225-8P2SV(cong)# interface vlan 1
WGS-5225-8P2SV(cong-if-vlan)# ip address 192.168.1.100
255.255.255.0
The previous command would apply the following settings for the Wall-mount
ManagedSwitch.
IPAddress:192.168.1.100
SubnetMask:255.255.255.0
4.Repeatstep1tocheckiftheIPaddresshaschanged.
6.2 StoringtheCurrentSwitchConguration
Atthe“#”prompt,enterthefollowingcommandandpress<Enter>.
# copy running-cong startup-cong
Figure 6-3: Saving Current Conguration Command Screen
If the IP is successfully congured, the Wall-mount Managed Switch will apply
the new IP address setting immediately. You can access the Web interface of
theWall-mountManagedSwitchthroughthenewIPaddress.