300Mbps 802.11n Wireless USB Adapter
WNL-U556M
-38-
setting of access point, and input it in the box; if you select
“PASSPHRASE”, you also need to select the length of the
key. The passphrase must be identical with the setting of
wireless access point you wish to connect to.
Key Index
Select WEP key index. For most of access points you can
select “1”, but please refer to the setting of the access point.
Network Key / Confirm
Network Key
When the encryption type is “WPA” or “WPA2-PSK”, it’s
required to input a set of “passphrases” to connect to wireless
access point. Please input the same passphrase in the two
boxes for confirmation.
EAP Type / Tunnel /
Provision Mode
When the authentication type is any of 802.1X, you have to
select the EAP type, tunnel, and provision mode from the
dropdown menu. This setting must be identical with your
802.1x authentication server.
Username / Identity /
Domain / Password
Please input 802.1x related authentication information here.
Certificate
If certification is required to authenticate with 802.1x
authentication server, please select a local certificate from the
dropdown list.
PAC
Check this box and PAC (Privilege Access Certificate) will be
automatically selected.
When all the required parameters are set, click “OK” to create and save a new profile.
4.1.2 Remove an existing profile
If you want to remove a profile no longer needed, click the “Profile” label and then select the existing
profile you wish to remove, and click the “Remove” button.
To Next Page
Loading...
Need help?
General
