7
INSTALLATION REQUIREMENTS
Electrical Requirements:
• PLATINUM requires 120 Volt 60 Hz power on a 15 amp fuse or circuit breaker.
Water Requirements:
• Water pressure of 40 to 75 psi is required for PLATINUM to operate correctly and safely.
• Water quality may affect the performance of PLATINUM. If you have water
quality concerns, such as high iron content, consult a water ltration expert.
• Some later model high-efficiency washing machines require water from both
the cold and hot water supplies even if a cold water cycle is selected. In this
case the To Washer and Household Use outlets can be connected to supply the
hot and cold water inlets on the washer, or a Y-valve can be used to connect
both the cold and hot water hoses from one of the PLATINUM outlet hose to the
washing machine.
PRIOR TO INSTALLATION:
1. Remove the unit from its packaging and inspect for any shipping damage.
2. Turn off the hot and cold water supplies/faucets to your washing machine.
3. Remove the cold water hose from the cold water faucet.
4. Set Flow Rate Dial for type of washer. (i.e. Top Load, Front Load) by turning the dial on
the rear of the unit to the correct setting.
To Next Page
Loading...