Need help?Do you have a question about the Platinum BLSL2250 and is the answer not in the manual?
General| Brand | Platinum |
|---|---|
| Model | BLSL2250 |
| Category | Gate Opener |
| Language | English |
Defines a gate operator for single-family dwellings, garages, or parking areas.
Defines a gate operator for multi-family housing, hotels, garages, or retail buildings.
Defines a gate operator for industrial locations like factories or loading dock areas.
Defines a gate operator for guarded industrial locations, e.g., airport security.
Defines inherent entrapment protection systems for gate operators.
Describes provision for non-contact sensors for gate operator safety.
Describes provision for contact sensors for gate operator safety.
Defines inherent adjustable clutch or pressure relief devices for gates.
Describes actuating devices requiring continuous pressure for gate operation.
Defines an audio alarm as an entrapment protection type.
Provides key technical specifications for the BLSL2250 gate operator.
Outlines periodic services for gate operator maintenance by professionals.
Details minimal maintenance tasks recommended for end users/home owners.
Illustrates the front installation configuration for the gate operator.
Illustrates the rear installation configuration for the gate operator.
Details requirements and recommendations for mounting on a concrete pad.
Describes essential pre-installation checks for gate and operator movement.
Details steps for leveling, paralleling, and anchoring the operator.
Details the correct procedure for installing the gate operator chain.
Explains how to use the manual release for gate operation.
Details the installation of contact sensors for entrapment protection.
Details the installation of photoelectric sensors for entrapment protection.
Describes how to install inductive loops when pouring a new concrete slab.
Details installing inductive loops by saw-cutting existing surfaces.
Explains installing inductive loops when resurfacing with asphalt.
Provides general recommendations for installing inductive loops.
Details the installation of the alarm reset switch as per UL 325 standard.
Describes the proper mounting of warning placards for safety compliance.
Details essential grounding procedures and power requirements for the operator.
Provides steps for connecting the main power supply to the gate operator.
Details connecting pre-wired harnesses for limit switches and motor control.
Details the procedure for setting gate open and close limit switches.
Explains the setup and learning cycle for gate opening and closing.
Provides a diagram for reconnecting limit switch wires if disconnected.
Details connections for safety accessories like photo beams and edge sensors.
Details connections for command accessories like keypads and fire overrides.
Explains how to configure photo beams for gate reopening.
Describes the two operational modes for a connected radio receiver.
Details the external power requirement for solenoid connections.
Explains wiring and function of the guard station control switches.
Describes how to set the operator as primary or secondary.
Details setting the maglock to engage before gate reaches open/close.
Explains the Auto-Open feature for power failure scenarios.
Details how to adjust the timer for automatic gate closing.
Explains the Leaf Delay for biparting gates with emblems or maglocks.
Describes how to adjust the obstruction sensor sensitivity.
Details the settings for Fail Safe and Fail Secure modes.
Provides instructions for installing a solar panel system for the operator.
Addresses issues where the gate operator motor fails to start or run.
Covers issues like stopping, reversing, or traveling over limit switches.
Troubleshoots problems with the gate not closing automatically.
Addresses problems with primary/secondary gate configuration.
Covers miscellaneous troubleshooting scenarios like alarms and beeping sounds.
To Next Page
