- 19 -
LED Light Show Animation Settings
For those sensitive to ashing lights, there are four modes that reduce LED animations:
STEP 1 Turn o the After Dark.
STEP 2 r Hold CTRL 1 and OSCILLATOR buttons.
STEP 3 While continuing to press the buttons down, turn the After Dark back on.
STEP 4 3 Use the MOD 2 knob to select the desired mode:
LED (8) green: Default light show animations.
LED (7) green: No extra animations when buttons are pressed.
LED (6) green: Static rainbow with no ashing.
LED (5) green: All LEDs o during play, except one to indicate power on.
STEP 5 Hold down KICK and SNARE buttons to lock selection. LEDs (1) + (16) ash green when setting is locked.
Volume Limit - The maximum volume of the After Dark can be reduced. This aects the volume from both the
speaker and the Audio Output jack.
STEP 1 Turn o the After Dark.
STEP 2 r Hold OSCILLATOR and CTRL 2 buttons.
STEP 3 While continuing to press the buttons down, turn the After Dark back on.
STEP 4 3 Use the MOD 2 knob to set maximum volume level. Red LED is on the left side: normal volume mode.
Red LED is on the right: reduced volume mode.
STEP 5 Hold down KICK and SNARE buttons to lock selection. LEDs (1) + (16) ash green when setting is locked.
To Next Page
Loading...
