Plettenberg NOVA 1 Series - Commissioning; Safety During Commissioning; Assembly & Mounting

OM_Plettenberg_Electric_Motors | Version 1 | 2023.07.14 13
4. Commissioning
Thermal overload / destruction
⚫ Always ensure sufficient cooling for the motor (air or water
cooling)
⚫ A high load on the motor is only permissible in short operation.
Under no circumstances must the motor exceed the
temperature of 100°C.
⚫ Only motor controllers and regulators approved by
Plettenberg must be used.
Safety during
commissioning
Severe, moderate or minor injuries.
Destruction or damage to the product
⚫ Safety instructions from Chapter 2 must be complied with!
⚫ Test runs with prop should only be executed outdoors or with
special safety equipment, such as caged test stand.
⚫ The side and front of the rotating plane needs to be kept clear.
Assembly &
mounting
Destruction / damage of the motor
⚫ Always use suitable screws or bolts.
⚫ Sawed or ground screws or bolts can destroy the thread in the
motor’s bearing shield.
⚫ After each use, the motor must cool down again to ambient
temperature.
⚫ Only motor controllers and regulators approved by Plettenberg
must be used.
⚫ Never exceed the maximum screw-in depth. Screws or bolts
which are screwed too far will damage or destroy the motor.
⚫ Only use original screws or bolts.
⚫ Do not use a sensor-guided motor against its specified
direction of rotation.