Need help?Do you have a question about the Plinius Hautonga and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Total Harmonic Distortion (THD) | < 0.05% |
| Signal to Noise Ratio | > 100 dB |
| Frequency Response | 20 Hz - 20 kHz |
| Inputs | 1 x XLR |
| Input Impedance | 47kΩ |
| Outputs | Speaker terminals, Pre-out |
Guidance on cleaning and maintaining RCA and other audio connectors.
Advice on periodic use of switches to ensure contact longevity.
Instructions for cleaning the exterior surfaces of the amplifier safely.
Description of the front panel display LED and its operational indicators.
Functionality of buttons for selecting audio inputs on the front panel.
Explanation of the small white LEDs indicating the current source.
Indicates when the HT Bypass input is active.
Details on using the motorized volume control knob.
Operation of the heavy-duty rocker switch for power control.
Details on connecting line-level and phono inputs.
Information on balanced XLR inputs for CD sources.
Switch for selecting between RCA and XLR CD inputs.
Input for home theatre processor bypass functionality.
Connection for outputting pre-amplified signal to an external amplifier.
Outputs for connecting to recording devices.
Binding posts for connecting loudspeakers, supporting bi-wiring.
Sockets for integrating with home theatre systems for power control.
Switch to disconnect signal ground to prevent hum loops.
Puts the unit into a low power mode, disconnecting outputs.
Button to adjust the brightness of the remote's white LEDs.
Buttons for scrolling left or right to select the desired input source.
Activates home theatre bypass mode, bypassing the preamplifier.
Buttons to increase or decrease the volume level of the amplifier.
Toggles the amplifier in and out of mute status.
CD player function to repeat all tracks from track 1.
Adjusts CD player display brightness between high, low, and off.
Buttons to cue forward or backward through tracks.
Buttons to move forward or backward through CD tracks.
Stops CD playback and opens the disc drawer.
Starts CD playback or pauses the current track.
Connecting source components using RCA or XLR interconnect cables.
Connecting loudspeakers to the amplifier's output terminals.
How to use the home theatre bypass input for multi-channel setups.
Connecting the amplifier as a pre-amp or sending signal to another amplifier.
Instructions for connecting the amplifier to the mains power supply.
Details on the 16-function remote control and battery replacement.
How to set the phono stage gain to high or low.
Information on rail fuses, LEDs, and replacement procedures.
Location and replacement of the mains fuse in the IEC socket.
Steps to take if the unit is not reproducing audio.
Possible causes and checks for quiet or distorted sound output.
Troubleshooting mains fuse failure or thermal overload protection.
To Next Page
