Pneumercator TMS3000 - TMS3000 Sensor Wiring

Quick Start-up Guide TMS Series
TMS Quick Start-up Guide.docx
Page 18 of 24 November 21, 2017
Figure 11A - TMS3000 Sensor Wiring
Liquid Level Control Systems
PNEUMERCATOR
Bulletin 174 Rev. B (12/07/15)
Page 1 of 2
IDENTIFY THE TYPE OF SENSOR(S) TO BE INSTALLED. WIRING MUST BE TERMINATED ON THE
TERMINALS INDICATED BELOW TO ENSURE CORRECT OPERATION.
IMPORTANT! TMS3000/TMS4000 SENSOR WIRING INSTRUCTIONS
2-WIRE SENSORS
3-WIRE SENSORS
Questions? Contact Technical Support at (800) 209-7858
BLK
RED
GND
SIG
+V
RSU801
NOTE: LS600 SUPPLIED WITH
CONDUCTOR COLOR PAIR PER
SWITCH POINT. REFER TO THE
TAG ATTACHED TO THE SENSOR.
LS600
LS600LD / LS610
BLK
RED
+V
SIG
4-PROBE/8-SENSOR
CARD WIRING
MODEL
16-SENSOR
CARD WIRING
GND
SIG
+V
ES825-200 SERIES
ES825-100 SERIES
+V
SIG
RED
W OR G
BLK
RED
W OR G
BLK
MODEL
16-SENSOR
CARD WIRING
4-PROBE/8-SENSOR
CARD WIRING
RED
BLK
W OR G
GND
SIG
+V
+V
SIG
GND
RED
BLK
W OR G
+V
SIG
+V
SIG
GRN
RED
BLK
+V
SIG
+V
SIG
GRN
RED
BLK
GND
SIG
+V
+V
SIG
GND
"W" = WHITE; "G" = GREEN
*
*
"W" = WHITE; "G" = GREEN
* RED IS COMMON GROUND WIRE
SEE PAGE 2 FOR TMS3000 SENSOR NUMBERING SEQUENCE
NOTE THE REVERSE ORDERING OF SENSOR INPUT NAMES
HS100D
(NON-DISCRIMINATING)
HS100D
(DISCRIMINATING)
RSU800
(DISCRIMINATING)
HS100ND
FIELD CABLE CONDUCTOR COLORS SHOWN.
FIELD CABLE CONDUCTOR COLORS SHOWN.
FIELD CABLE CONDUCTOR COLORS SHOWN.
RSU800
(NON-DISCRIMINATING)
FIELD CABLE CONDUCTOR COLORS SHOWN.