Pneumercator TMS3000 - Programming for RA100;RA200 Remote Annunciator

Quick Start-up Guide TMS Series
TMS Quick Start-up Guide.docx
Page 24 of 24 November 21, 2017
RA100R/RA200KR Remote Alarm Programming
Note: For wiring, refer to: Figure 12 for RA200KR.
Figure 13 for RA100R
The following wiring scenario is being provided as a guideline only. The advantage to wiring
the CC Inputs as illustrated is to use the Reset switch in combination with the Test switch. The relays
can be wired in any combination. This is the way your system will be preprogrammed if supplied with
an RA100/RA200 alarm.
Programming:
1. Sets the tank conditions that must occur to activate the relays. Factory default conditions shown
below activate for SP1 (Above 95% volume) and SP2 (Above 90% volume).
Front Panel TMS Communicato
r
Config  Rely Tank Configuration  Relays  Tank Triggers
Relays Relays
Leak Trig no.no.no Leak Trigger None - None - None
SP1 Trig 01.02.no Set Point #1 Trigger Relay #1 - Relay #2 - None
SP2 Trig 01.02.no Set Point #2 Trigger Relay #1 - Relay #2 - None
SP3 Trig no.no.no Set Point #3 Trigger None - None - None
H2O Trig no.no.no Water Trigger None - None
–
None
2. Chooses the CC Inputs (wired to RS2) that the relays will react to.
Front Panel TMS Communicato
r
Config  Rely cc Configuration  Relays  Non-Hazardous Contact Closure Inputs
cc Trig Relays CC Trigger Relay Selects
1 02.no.no #1 Relay #2
–
None
–
None
2 01.02.no #2 Relay #1
–
Relay #2
–
None
3. Controls the behavior of a relay.
Front Panel
Config  Rely Mode
Relay Normally FP Ack Delay Latch En
1 Off No None No
2 Off Yes None No
TMS Communicato
r
Configuration  Relays  Relay Mode
Relay Normal Contact State Allow Front Panel Acknowledgements Delayed Shutof
f
Latch Enable
#1 Off

None

#2 Off

None

4. Controls the behavior of a Contact Closure Input. Note: Only settings used for supporting the RS2 are
listed below. Do not change the factory default values for other unlisted settings.
Front Panel
Config  cc Input
CC Input cc Enable Normally
1 Ack Open
2 Relay Open
TMS Communicato
r
Configuration  Contact Closure Inputs  Non-Hazardous Contact Closure Inputs
CC Input Contact Closure Enable Normally
#1 Acknowledge Open
#2 Relay Open
Contact Closure 1 Reset
Contact Closure 2 Test
Relay 1 Strobe
Relay 2 Horn