To charge your POGS The Gecko 2, you will need a universal USB-C charging cable. This
cable is not included in the box with your headphones, yet available as optional accessory at
www.pogsheadphones.com or any other electronics store.
One of our POGS principles is to reduce our impact on the environment and to minimize waste. Most
households already have USB-C charging cables, so adding these in the box can result in many
unused cables. Instead, we offer the cable as an accessory if needed.
When battery is below 20%, the LED logo light will blink every 30 seconds. A battery low audio
prompt will be given when battery reaches 20%, 10% and 5% of capacity.
When charging the logo light will be on. After charging, the headphones will be off and will need to
be turned on again to use.
If you are out of battery, The Gecko 2 can still be used with an audio cable. Equally, when using The
Gecko 2 where a wireless connection is not possible, like in an airplane, an audio cable can be used.
Please always use the POGS-Safe cable when using the product with cable (available on
www.pogsheadphones.com).
When using a cable to connect to your output device when out of battery, please make
sure you are using the POGS-Safe cable. This cable has unique built-in technology to limit
the volume to a maximum of 85 dB, which other audio cables do not.
To prolong battery lifespan, fully charge at least once every 3 months. Battery life varies by
use and settings.
For your safety, the headphones cannot be used during charging.
To Next Page
