15
3/3 PLAYERS
Add players to your team.
1. Choose Add new players.
2. Fill in the player information fields.
3. ADDPLAYERTOTHETEAM must chosen after creating each player profile. Otherwise the player
will not be added to the team.
The players added to the team are shown on the right side panel
Choose DONE when you have added all the players to the team. Then choose NEXT. Welcome to the team
is shown on the screen when you have finished the team setup wizard.
DOWNLOAD POLAR TEAM PRO APP ONTO YOUR IPAD
After completing the team setup in the Polar Team Pro web service, it's time to finalize the first time setup by
downloading the Polar Team Pro app, and syncing the player information via the Polar Pro team dock to the
sensors.
1. Download the Polar Team Pro app onto your iPad from the App Store.
2. Login to the app with the same account details that you used with the Polar Team Pro web service.
3. Place the iPad into the dock. Make sure it is properly leveled and resting firmly against the base.
4. The SENSORS & DOCK view appears on the iPad screen.
5. Tap Auto assign in the upper left corner to assign the sensors to the players.
6. When a sensor is assigned the player number and a green check mark is displayed on each sensor on
the iPad screen, and
Your Polar Team Pro solution is now set up, and ready for the first training session.
CHARGING
CHARGING POLAR PRO TEAM DOCK
Plug your dock into an outlet with the AC adapter and the AC power cord for your region. Only use the AC
adapter unit and AC power cord provided with your dock. The AC adapter is for indoor use only. Only charge
the dock and sensors indoors.
CHARGING POLAR PRO SENSORS
Charge the sensors in a Polar Pro team dock. Detach the sensors from the straps, and place them into the
dock and snap them firmly into place (make sure both ends of the sensors snap into place). When the Polar
logos on the sensors and dock face the same way, the sensors are placed correctly. Charging the
sensors from empty to can take three hours.
To Next Page
Loading...
