64
MAINTENANCE
Lubrication Recommendations
11. Front A Arm
Pivot Shaft
Grease**∆ Locate fitting on pivot shaft and
grease with grease gun.
Every 3
months or 50
hours
12. Swing Arm
Bushings
Grease** Locate fittings on swing arm and
grease with grease gun.
Monthly or at
20 hours
13. Upper Control
Arms
Grease**∆ Locate fittings and grease Semi-annually
14. Lower Control
Arms
Grease**∆ Locate fittings and grease Semi-annually
15. Center Wheel
Hub Bearing Car-
rier
Grease**∆ Locate fitting and grease Semi-annually
16. Tail Shaft
Coupler
Grease**∆ Locate Fitting and grease Monthly or at
20 hours
17. Center and
rear angle drives
GL5 80-90
weight
gear lube
Fill to bottom thread of filler hole.
Make certain machine is on a level
surface.
Monthly or at
20 hours
* More often under severe use, such as wet or dusty conditions.
**Polaris Premium all Season Grease or grease conforming to NLGI No. 2, such as
Conoco Superlube M or Mobilegrease Special.
+ Grease every 500 miles, or after submerging in water or before long periods of storage or
after pressure washing. Always use Polaris Premium U-Joint Lube for maximum service of
these driveline components (PN 2871515 3 oz.)(PN 2871551 14 oz.).
∆ When suspension action becomes stiff or after washing.
NOTE: Hours are based on 10 mph average.
To Next Page
Loading...
