Polaris 2015 RZR 900 - User Manual

Other manuals for Polaris 2015 RZR 900

Questions and Answers:

J
Jose HillAug 13, 2025
What to do if my Polaris Offroad Vehicle engine turns over but fails to start?
- K
  Kathryn McgeeAug 13, 2025
  If your Polaris Offroad Vehicle's engine turns over but fails to start, the issue could stem from several causes. First, ensure you have fuel in the tank by refueling if necessary. Other potential causes include a clogged fuel filter (in which case you should see your dealer), water in the fuel (drain and refuel), or using old or non-recommended fuel (replace with fresh, recommended fuel). Also, inspect the spark plugs for fouling or defects and replace if needed. Check for spark at the spark plug, and recharge the battery to 12.8 VDC if the voltage is low. Inspect and tighten any loose ignition connections. If water or fuel is present in the crankcase, immediately see your dealer. Mechanical failure can also be a cause, requiring dealer assistance.
T
Thomas PageAug 16, 2025
Why won't my Polaris Offroad Vehicle engine turn over?
- L
  Lori RubioAug 17, 2025
  If your Polaris Offroad Vehicle engine doesn't turn over, it could be due to low battery voltage, in which case you should recharge the battery to 12.8 VDC. Check and tighten any loose battery connections, solenoid connections, and electronic control box connections. For mechanical failure, consult your dealer.
N
Nicole SmithAug 20, 2025
How to prevent drive belt wear or burn in my Polaris Offroad Vehicle?
- A
  Abigail PetersAug 20, 2025
  Drive belt wear or burn in your Polaris Offroad Vehicle can occur due to several reasons. To prevent this, use low range when loading onto a pickup or tall trailer, starting out on steep inclines, hauling heavy cargo, plowing, or when stuck in mud or snow. If you are climbing over large objects from a stopped position, shift to low range and use quick, aggressive throttle. Also, ensure you warm the engine for at least 5 minutes in low ambient temperatures, and use the throttle quickly and effectively. Avoid driving at low RPM or ground speed. Always warm up the belt and use the recommended belt. If belt slippage occurs due to water or snow, dry out the PVT. If the belt has failed, remove debris from the clutch box and install a new belt.
A
Anna BennettAug 25, 2025
Why does my Polaris Offroad Vehicle engine stop or lose power?
- T
  taylormeganAug 25, 2025
  If your Polaris Offroad Vehicle engine stops or loses power, it could be due to several reasons. Check if you are out of fuel and refuel if necessary. Inspect and replace any kinked or plugged fuel tank vent line or filter. Replace the fuel if water is present or if incorrect fuel is being used. Inspect, clean, and/or replace fouled or defective spark plugs, ensuring the spark plug gap is set to specifications. Check and tighten any loose ignition connections. Recharge the battery if the voltage is low. If the engine is overheated, clean the radiator screen and core, clean the engine exterior, and check the coolant level. For worn or defective spark plug wires or other mechanical failures, it's best to consult your dealer.
H
halljessicaAug 28, 2025
What to do if my Polaris Offroad Vehicle drive belt slips due to water or snow?
- A
  Allison GilesAug 28, 2025
  To address belt slippage from water or snow ingestion into the PVT system of your Polaris Offroad Vehicle, dry out the PVT. Also, prevent water from entering the PVT outlet duct. If repeated leaking occurs, inspect the clutch seals for damage.
D
Deborah WilkersonAug 31, 2025
Why does my Polaris Offroad Vehicle engine run irregularly, stall, or misfire?
- M
  Matthew PrinceSep 1, 2025
  If your Polaris Offroad Vehicle engine runs irregularly, stalls, or misfires, several factors could be responsible. Start by inspecting, cleaning, and/or replacing fouled or defective spark plugs, and ensure the spark plug gap is set correctly. Check and tighten any loose ignition connections. If water is present in the fuel, replace it with new fuel. Recharge the battery if the voltage is low. Inspect and replace any kinked or plugged fuel tank vent line or filter, as well as any kinked idle air control lines. Ensure you are using the recommended fuel and inspect/replace the air filter if it's clogged. For worn or defective spark plug wires or other mechanical failures, it's best to consult your dealer.
M
Marvin SchwartzSep 4, 2025
What causes my Polaris Offroad Vehicle engine to backfire?
- J
  Julia MartinezSep 4, 2025
  If your Polaris Offroad Vehicle engine backfires, several issues could be the cause. Ensure you have enough fuel by refueling if necessary. Inspect, clean, and/or replace spark plugs if they are weak. Set the spark plug gap to specifications or replace the plugs if they are incorrect. Replace old or non-recommended fuel with fresh, recommended fuel. Check and tighten any loose ignition connections and check all exhaust connections for leaks. For incorrectly installed spark plug wires, incorrect ignition timing, or mechanical failure, consult your dealer.
B
bmccarthySep 8, 2025
What causes my Polaris Offroad Vehicle engine to ping or knock?
- E
  Eric KirbySep 8, 2025
  If your Polaris Offroad Vehicle engine pings or knocks, it could be due to poor quality or low octane fuel; replace it with the recommended fuel. Also, ensure the spark plug gap is set to specifications or replace the plugs if they are incorrect. For incorrect ignition timing, consult your dealer.