Polaris RANGER RZR XP 4 900 2013 User Manual (English)

Questions and Answers:

L
Laura EspinozaAug 3, 2025
Why is my Polaris RANGER RZR XP 4 900 2013 engine backfiring?
- C
  Charles FordAug 3, 2025
  If your Polaris Utility Vehicle engine backfires, start by refueling the vehicle. A weak spark from the spark plug could also be the issue, so inspect, clean, or replace the spark plugs. Make sure the spark plug gap and heat range are correct. Replace old or non-recommended fuel with fresh, recommended fuel. Check all ignition connections and tighten if loose. If there is water in the fuel, replace it with fresh recommended fuel. Check all exhaust connections.
R
Robert DiazAug 7, 2025
How to prevent drive belt wear on my Polaris RANGER RZR XP 4 900 2013 Utility Vehicle?
- J
  Julie SweeneyAug 8, 2025
  To prevent drive belt wear or burn on your Polaris Utility Vehicle, especially when loading onto a pickup or tall trailer, use low range. When starting on a steep incline, also use low range. If driving at low RPM or ground speed (3-7 MPH), increase your speed or use low range more often.
J
Joel LloydAug 11, 2025
What to do if my Polaris RANGER RZR XP 4 900 2013 Utility Vehicle engine turns over but won't start?
- N
  nnelsonAug 11, 2025
  If your Polaris Utility Vehicle engine turns over but fails to start, first, refuel the vehicle. If that doesn't work, the fuel filter may be clogged, or there may be water in the fuel. In this case, drain the fuel system and refuel. Also, old or non-recommended fuel can cause this issue, so replace it with fresh, recommended fuel. Inspect the spark plugs and replace if needed. Check all ignition connections and tighten if loose. Ensure the battery is charged to 12.8 VDC.
K
Kimberly SanfordAug 16, 2025
Why does my Polaris RANGER RZR XP 4 900 2013 engine keep stopping or losing power?
- C
  chrishurleyAug 16, 2025
  If your Polaris Utility Vehicle engine stops or loses power, the first step is to refuel it. Other potential causes include a kinked or plugged fuel tank vent line or filter, which you should inspect and replace if necessary. If there's water in the fuel, replace it with new fuel. Inspect, clean, or replace fouled or defective spark plugs, and ensure the spark plug gap and heat range are correct. Also, check and tighten any loose ignition connections, and make sure the battery is charged to 12.8 VDC. Replace incorrect fuel with fresh, recommended fuel, and inspect and clean or replace a clogged air filter. Clean radiator screen and core, clean engine exterior, check coolant level, see your dealer if condition persists.
C
Christine JensenAug 20, 2025
What causes my Polaris RANGER RZR XP 4 900 2013 engine to stall or run irregularly?
- R
  Russell JenningsAug 20, 2025
  If your Polaris Utility Vehicle engine runs irregularly, stalls, or misfires, inspect, clean, or replace the spark plugs. Ensure the spark plug gap and heat range are correct. Check all ignition connections and tighten if loose. Replace the fuel if water is present. Recharge the battery to 12.8 VDC if the voltage is low. Inspect and replace a kinked or plugged fuel tank vent line or filter. Inspect kinked idle air control lines, and rotate lines to remove the kink. Replace incorrect fuel with recommended fuel, and inspect and clean or replace a clogged air filter. Add or change fuel, clean the fuel system if fuel is low or contaminated. Replace with recommended fuel if fuel is low octane.