GEM Owner’s Manual - Page 58
As the picture shows on page 56, the release handle is located on the
back panel, just below the rear window opening ledge.
To remove or install rear accessories:
1. Remove contents of rear accessory.
2. Steady it to prevent it from falling.
3. Unlock the release handle with ignition key.
4. Rotate the release handle clockwise to release.
5. Remove the safety strap.
6. Lift off the GEM car.
7. Position the new rear accessory onto the brackets and refasten the
safety strap.
8. Push forward to engage lock. Test to make sure it is secure. This is
a two stage locking system. If not secure, repeat procedure.
9. Lock the release handle with ignition key.
Keep the back latch in a locked posion when operang or transporng the vehicle.
The rear accessory could fall and cause injury if the safety strap is not used.
NOTICE
The capacity of the back is not intended for any type of passenger use. Doing so
could result in death or serious injury.
WARNING
Understanding the Optional
Features of Your Vehicle
To Next Page
Loading...
