95
MAINTENANCE
Vehicle Immersion
If it's impossible to take your RANGER to a dealer before starting it, fol-
low the steps outlined below.
1. Move the vehicle to dry land or at the very least, to water below the
footrests.
2. Dry any water present in the air box.
3. Filter replacement is required if water is present.
4. Thoroughly dry the air pre-cleaner located under the hood.
5. Remove the spark plugs.
6. Turn the engine over several times using the electric start.
7. Dry the spark plugs and reinstall, or replace with new plugs.
NOTE: Attempt to start the engine. If necessary, repeat the drying procedure.
8. Take the vehicle to your dealer for service as soon as possible,
whether you succeed in starting it or not.
NOTE: If water has been ingested into the PVT follow the procedure on page
82 for drying.
CAUTION
If your vehicle becomes immersed, major engine damage can result if the
machine is not thoroughly inspected. Take the vehicle to your dealer before
starting the engine.
To Next Page
Loading...
