LEFT HAND CONTROL ALIGNMENT
1. Loosen the four control block mounting screws.
CAUTION
Take care to avoid damaging hand warmer/brake switch wires when moving
components.
2. Move the control block to the desired position.
NOTICE
If the control is loose and was inadvertently moved without loosening the
screws, move the control block slightly to the left or right to relocate the pins.
3. Tighten the screws to specification in the sequence shown in the image. Do
not over-torque.
TORQUE
Control Block Mounting Screws
24 in-lbs (2.7 N·m)
46
THE PERFECT FIT
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
