Polaris 650 2023 - Page 105

1. Slightly loosen the set screw
t
on the bottom of the
housing.
2. Move the switch to the
desired position.
3. Tighten the screw to
specification. Do not
over-torque.
TORQUE
Engine Stop Switch Mounting Screw
12 in-lbs (1.4 N·m)
HANDLEBAR HOOK ALIGNMENT
1. Slightly loosen the hook
mounting screw
q
. Do not
remove the screw.
2. Rotate hook to the desired
position.
3. Torque screw to
specification. Do not
over-torque.
TORQUE
Handlebar Hook Screw
10 ft-lbs (13.5 N·m)
103
THE PERFECT FIT