9. Secure the right fender using the plastic rivet.
10.Reinstall the console using the two plastic rivets. Reinstall the side panel.
BATTERY CHARGING
To ensure your battery maintains its level of charge, the battery should be
connected to a battery trickle charger using the battery charge port
q
.
1. Check the battery voltage with a
voltmeter or multimeter. A fully
charged battery will register 12.8 V
or higher.
2. If the voltage is less than 12.8 volts,
recharge the battery at 1.2 amps or
less until the battery voltage is 12.8
or greater using the battery charge
port
q
.
RESTRICTION
When using an automatic charger, refer to the charger manufacturer's
instructions for recharging. When using a constant current charger, use the
following guidelines for recharging.
WARNING
An overheated battery may explode, causing severe injury or death. Always
watch charging times carefully. Stop charging if the battery becomes very
warm to the touch. Allow it to cool before resuming charging.
TIP
Always verify battery condition before and 1-2 hours after the end of charging.
State of Charge Voltage Action Charge Time*
100% 12.8-13.0 volts None, check at 3 mos.
from date of
manufacture
None required
75%-100% 12.5-12.8 volts May need slight
charge, if no charge
given, check in 3
months
3-6 hours
50%-75% 12.0-12.5 volts Needs charge 5-11 hours
166
MAINTENANCE
To Next Page
Loading...
Need help?
General
