FINAL DRIVE
7.26
3. Inspect bearing.
NOTE: Due to extremely close tolerances and
minimal wear, the bearings must be inspected
visually, and by feel. While rotating bearings by hand,
inspect for rough spots, discoloration, or corrosion.
The bearings should turn smoothly and quietly, with
no detectable up and down movement and minimal
movement sideways between inner and outer race.
4. Inspect bearing housing for scratches, wear or
damage. Replace housing if damaged.
MID DRIVE BEARING
CARRIER/HUB ASSEMBL
Y
(6X6)
1. Support bottom of bearing carrier housing. (A)
Bearing Carrier Housing; (B) Bearing; (C) Snap
Ring
A
B
C
2. Start bearing (B) in housing (A).
B
A
3. Press bearing into place until outer race bottoms on
housing.
CAUTION:
Use an arbor and press only on the outer race, as
bearing damage may occur.
4. Install snap ring into groove.
To Next Page
Loading...
