Polaris A11RD50AA - Page 193

FINAL DRIVE
7.35
MID DRIVE GEARCASE
ASSEMBL
Y
1. Install the shim (A) and a new retaining ring (B)
onto the output end of the output thru shaft (C).
Install the output thru shaft into the gearcase.
A&B
Gearcase
C
2. Install the 26T input gear (D), shim (E), and a new
retaining ring (F) onto the output thru shaft.
D
E
F
3. Assemble the pinion shaft assembly (if previously
disassembled). Install the 26T gear (G) and
bearing (H) onto the pinion shaft (I).
NOTE: When replacing the 26T output, be sure the
step of the gear is facing towards the bearing (See
Below and next page).
Step Of Gear
I
H
Pinion Shaft Assembly
G