FINAL DRIVE
7.37
7. Install the wave spring (L) into the gearcase
assembly. Be sure the wave spring is fully seated
into the bearing cup of the gearcase.
L
8. Install the output shaft and ring gear into the
gearcase. Be sure the 10T input pinion gear and
the output pinion gear mesh smoothly.
Output Shaft / PInion Gear
9. Install the shims (M) into the output cover (N).
Install the shims in the order that they were
removed during the disassembly process.
N
M
10. Install a new O--ring (O) onto the output cover .
O
11. Carefully install the output cover onto the
gearcase. Install the output cover bolts. Torque
the bolts to 18--23 ft. lbs. (24--31 Nm).
Cover Bolts: 18--23 ft.lbs. (24--31 Nm)
To Next Page
Loading...
