FINAL DRIVE
7.50
3. Install the pinion shaft into the differential housing.
Install a new O--ring onto the pinion shaft cover.
Install the cover and torque the cover bolts to 20
ft. lbs. (27 Nm).
Pinion Gear Cover
New O--ring
4Bolts
Pinion Shaft Cover Bolt Torque:
20 ft. lbs. (27 Nm)
4. Install a NEW seal, O--ring, and retaining ring onto
the actuator if the actuator was removed. Install
the actuator into the differential housing. Be sure
the retaining ring fully seats into the groove in the
differential cover.
Retaining Ring Groove
Install Actuator
5. Reinstall the the original shims and snap ring onto
the output shaft.
To Next Page
Loading...
