62
CONTROLS AND FEATURES
Features
Electronic Speedometer
When the programmed hours are reached, SEr hr will light; when the
programmed distance is reached, SErdIS will light. Each time the
vehicle i s started, the reminder will turn on and remain lit until the
button is pushed or the speedometer is reprogrammed for the next
service interval.
Accessing Sub-menu Features
There are two methods for accessing the sub menu:
1. Press and hold the button and turn the power on
2. Press and hold the button for 8 seconds
Hold the button until the display shows POLArS then release the
button. The speedometer is now in the sub-menu. To display each
mode, press the button once to scroll through the four available
functions. Each function will be displayed as follows:
Service Hours SET hr
Service Distance SETdIS
Miles to Kilometers COnvrT
No Menu Changes DOnE
Changing Distance Measurement
1. Access the sub-menu
2. Select COnvrT and release the button. If the last digit in the
odometer display is K, the current measurement is kilometers; if
the last digit is M, distance is being measured in miles.
To Set Service Hours
1. Access the sub--menu
2. Toggle to SET hr, then release the button.
3. In 3 seconds, the LCD will display 5 digits, with the left--most
digit flashing.
4. Within 4 seconds, press and release t he button to change the digit.
Once the digit is changed once, the button may be held to scroll
through the digits from 0 to 9.
5. After the digit has been selected, do not push the button. After 4
seconds the next digit will flash.
To Next Page
Loading...
Need help?
General
