63
CONTROLS AND FEATURES
Features
Electronic Speedometer
Setting Service Hours (cont.)
6. Repeat step 4 and 5 to program the digits for the service interval
selected. (i.e. for service interval of 50 hours set the display to
show: 00050 H)
7. To save the changes press and hold t he button when any one of the
digits is flashing.
8. The display will change to DOnE. At this time release the button
and the changes are now saved.
TO CHECK WHEN SERVICE IS DUE BY HOURS
Using the 50--hour service setting example from above, the
speedometer will take the 50 --hour setting and add it to the value of the
hour--meter. This will be the value displayed when the operator checks
when service is due for t he ATV. For example, the hour meter reading
is 132 hours, and t he service interval was set for 50 hours, the 5--digit
display will show 182 hours.
1. Access the sub--menu
2. Toggle to SET hr , then release the button
3. In 3 seconds, the LCD will display 5 digits, with the left--most
digit flashing. As in the example above, the display would show
00182 H.
4. Either turn the power off or not touch t he button for 35 seconds to
maintain the current settings.
To Next Page
Loading...
Need help?
General
