5.1 Setting the Clock
The saltwater chlorine generator is fitted with an internal
memory and is fitted with battery back up that will
maintain memory for several weeks in the event of a
power failure. The time is displayed in a 24 hour format.
Switch on the device and wait until screen start-up
sequence is finished.
to correctly treat the water. The saltwater chlorine
generator has default settings of Timers 1 and 2.
However they can be customized.
The saltwater chlorine generator can store 2 seasonal
operating modes called by default "SMR" and "WIN".
The following settings can be customized for each mode:
- the device operating times, the "timers": T1 (Timer 1)
and T2 (Timer 2)
- the required chlorine production rate: 10 %, 20 %, 30
%,... up to 100 %.
STANDBY = Device operating status
T = “Timer” mode (always active)
SMR = “Summer” operating mode
80 % = chlorine production rate
14:25 = time in 24 hr format
Mode Selection: “SUMMER” or “WINTER”
•
Press
4 times to set the clock. “SMR” starts to
flash.
•
Use the
and
buttons to choose “SMR” or
“WIN” mode, then press the button to return to
the home screen.
Programming the Timers According to the Modes
The times of Timers 1 and 2 cannot overlap. In addition,
the time range of Timer 1 necessarily precedes that of
Timer 2.
TS1 / TS2 = Timer in “summer” mode No. 1 / Timer in
“summer” mode No. 2
08:00-12:00 = Operating time range of Timer No. 1
14:00-20:00 = Operating time range of Timer No. 2
•
Press the button to access the user menu, the
minutes start to flash.
•
Use the and buttons to set the minutes, then
press to store.
•
Use the
and
buttons to set the hours, then
press to store.
•
Press the button to return to the home screen.
5.2 “Summer” and “Winter” Modes and
Setting the “Timers”
"Timer" programming is used to define the device
operating times within the filtering system operation
times. The daily operating times must be sufficient
•
Press
4 times to set the clock. “SMR” starts to
flash.
•
Select the mode to be customized “SMR” or “WIN”
using the
and
buttons, then press to
store and move to the timer setting screen.
•
Use the
and
buttons to set the Timer 1 stop
minutes, then press to store.
•
Use the and buttons to set the Timer 1 stop
hours, then press to store.
To Next Page
Loading...
Need help?
General