95
SPECIAL PROCEDURES
Submerged (Waterlogged) Engine
5. Upright the watercraft.
6. Inspect, dry and install new spark plugs. Install the air intake.
7. Check the battery vent hose for obstruction; drain water from the
hose if present.
8. Check gas and oil for the presence of water. If water is present take
the watercraft to an authorized dealer for immediat e service. Do
not run the watercraft if water is present in the gas or oil. Verify
that no air is present in the oil line.
9. Grease driveshaft and bearing housing following instructions on
page 108.
10. Reinstall drain plug. Reinstall the seat.
11. Follow starting procedures as described on page 74.
To wing The Watercraft In Water
If the watercraft becomes inoperable in t he water it can be towed. Tie
about 20 feet (6 m) of tow rope to the eye located on the bow. Slowly
tow the watercraft to shore at idle speed.
Battery Information
If the watercraft battery is run down, it should be removed and charged.
See the maintenance section of this manual for battery charging
recommendations, pages 116 to 120.
A weak battery can leave you stranded which could result in severe
injury or death. Never operate the watercraft with a battery that is
very weak and may not start the engine on its own.
WARNING
If your watercraft has a fuel valve, always turn it off when
transporting or storing the watercraft. Fuel valve location varies
with certain models. Know your machine before operating.
WARNING
To Next Page
Loading...
Need help?
General
