EasyManuals Logo

Polaris FREEDOM Plus EB37 Series User Manual

Polaris FREEDOM Plus EB37 Series
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Page 12
Polaris
®
FREEDOM
PLUS Cordless Robotic Cleaner | Owner’s Manual
2. Choose “Robotic Cleaner” from the list and
choose your model type.
3. Follow on screen prompts to pair your cleaner.
4. Slide the slider right and HOLD for ten
seconds to put the cleaner in Pairing Mode.
Wi-Fi LED Indicates Connection Status
BLINKING - pairing
SOLID - connected to internet
Figure 17. Slide and Hold Right to Pair
5. Follow on-screen prompts to add your cleaner
and connect to your home router.
NOTE: If you have problems connecting, the Wi-Fi
signalmay not be strong enough next to
the pool. Try placing the charging station in
another location closer to your home router
(seeiAquaLinkTroubleshooting section.)
Section 5. iAquaLink
®
Control
IMPORTANT
WiFi signals cannot travel underwater. Most app functions are therefore
not available during a cleaning cycle.
Place the cleaner back on the
charging stand to reconnect to the WiFi.
WARNING
Do not enter pool while the robotic cleaner is in water.
5.1 iAquaLink
®
Control Home Screen
App function and design is subject to change.
Start Cleaning
Clean Mode
Battery Charge Status
Green Charged: Fully Charged
Green Charging: Ready For Use
Orange Charging
Orange Partially Charged
5.2 Set Cleaning Mode
Start Cleaning
1. From the main screen, select Cleaning Mode
toview options.
2. Select Cleaning Mode. The factory default
cleaning mode is Floor/Wall.
3. From the Home screen, press the Start button
to begin cycle. The cleaner will start when it
detects water and will cancel the cycle if not
submerged after 5 minutes.
NOTE: At the beginning of each cleaning cycle,
the robot confirms your pool parameters
(approximately 10minutes). During this time,
thecleaner does notclimb to the waterline.
Cleaning Mode Select Runtime
Floor/Wall Product or App 2.5 hrs
Floor Product or App 1.5 hrs
SMART In App Calculated
Waterline In App 0:45 min
SMART Cycle
SMART Cycle calculates a customized cleaning
time optimized for your pool. On the first run of
SMART Cycle, the app counts up as it calculates
the optimized cleaning time.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris FREEDOM Plus EB37 Series and is the answer not in the manual?

Polaris FREEDOM Plus EB37 Series Specifications

General IconGeneral
BrandPolaris
ModelFREEDOM Plus EB37 Series
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals