Polaris 9400 Sport 4WD User Manual (English)

Questions and Answers:

J
Jeremy OrtizJul 27, 2025
Why is my Polaris 9400 Sport 4WD Vacuum Cleaner not cleaning effectively?
- K
  Karen ArmstrongJul 27, 2025
  If your Polaris Vacuum Cleaner isn't cleaning effectively, several factors could be at play. First, check if the filter canister is full or dirty and clean it. Also, inspect the brushes; if they're smooth or the wear indicator is visible, they should be replaced. Finally, ensure the floating cable is spread out, not excessively coiled or kinked; if it is, straighten it in the sun to remove kinks.
D
danielbassAug 1, 2025
What to do if my Polaris 9400 Sport 4WD does not stay on the pool bottom?
- J
  jillrodriguezAug 1, 2025
  If your Polaris Vacuum Cleaner doesn't stay firmly on the pool bottom, it could be due to air in the appliance casing. Submerge the cleaner. Alternatively, the filter canister might be full or dirty, so clean the filter canister.
L
Luis WongAug 7, 2025
What to do if my Polaris 9400 Sport 4WD Vacuum Cleaner does not move on startup?
- M
  Ms. Lori WoodAug 7, 2025
  If your Polaris Vacuum Cleaner doesn't move on startup, first ensure it's receiving electricity by checking the outlet the control unit is connected to. Also, verify that you've started one of the two programs and that the indicator light is on. If the problem persists, contact your local service representative.
B
Brandon GardnerAug 14, 2025
How to stop Polaris 9400 Sport 4WD Vacuum Cleaner cable from tangling in the pool?
- D
  Donna RobinsonAug 14, 2025
  If your Polaris Vacuum Cleaner cable is tangling, it might be due to too much cable length in the water. Avoid unraveling the entire cable; place only the necessary length in the pool and keep the rest on the side.
W
wardpaulaAug 20, 2025
Why doesn't my Polaris Vacuum Cleaner climb the pool sides?
- B
  Bradley GarciaAug 20, 2025
  Your Polaris Vacuum Cleaner may not climb the pool sides because the filter canister is full or dirty, so you should clean it. Another reason may be that the pool sides are slippery or slimy due to microscopic algae. In this case, perform a shock chlorination treatment, slightly reducing the pH, and remember not to leave the cleaner in the pool during this treatment.