Page 6
Polaris
®
FREEDOM
™
PLUS Cordless Robotic Cleaner | Owner’s Manual
Section 2. Cleaner Specifications
2.1 General Specifications
The general specifications for the cleaner are as
follows:
WARNING
Only use the battery charger supplied with the cleaner.
Charge Station Supply
Voltage
110-240 VAC; 50/60 Hz
Class II*
Supply Voltage 29.4 V DC
Battery Capacity 9.6 Ah
Operating Power 29.4 W
Cleaner Size (WxDxH) 16 x 16.5 x 11 inches
(41 x 42 x 28 cm)
Weight of Cleaner 20 lbs (9.1 kg)
Packed Weight 36 lbs (16.5 kg)
Filtration All-purpose filter canister
Cycle Lengths Variable programming
Charge Temperature Max 95°F (35°C)
Min 40°F (5°C)
Water Temperature
Range
Max 95°F (35°C)
Min 55°F (13°C)
Operating Depth Max 13 ft. (4 m)
Min 15 in. (40 cm)
*Class II: An appliance with double insulation
or reinforced insulation that does not require
grounding.
2.2 Contents
The packaging should contain the following items:
• Polaris Cleaner
• Removal Hook
• Charging Caddy
• Remote Control
Figure 1. Contents
Section 3. General Cleaner
Operation
3.1 Assemble the Charging Station
1. Insert the charging station onto the charging
caddy. Firmly push the charging station guides
into the charging caddy holes until charging
station issecure, see Figure 2.
Figure 2. Assemble Charging Station
Refer to the charging caddy assembly document
for charging caddy assembly instructions.
CAUTION
To prevent damage to the cleaner, be sure to adhere to the following
guidelines:
• Remove the cleaner from the pool after the cleaning cycle is
completed.
• Store out of direct sunlight or inclement weather.
• For retrieval, either use the remote control to activate Lift system
or use the manual retrieval hook, then pickup at waterline.
• Take additional care when lifting the cleaner out of the pool.
Itbecomes heavier when filled with water.
• Always remove the cleaner from pool when super chlorinating
or adding acid.
• Do not handle cleaner while it is in operation.
• Ensure that the cleaner is not in running mode before handling.