Page 8
Polaris
®
FREEDOM
™
PLUS Cordless Robotic Cleaner | Owner’s Manual
3.3 Information/Status LEDs
Battery Status
Solid Green
Fully charged.
Blinking Green
Ready to run a full cycle (2 h 30 min).
Solid Orange
Not fully charged. May not run a complete floor & wall
cycle.
Blinking Orange
Very low battery level. Charge required. Cannot run
cleaner.
Blinking Red Charging error. Cleaner is too hot.
Wi-Fi Connection Status
Blinking Blue Pairing.
Solid Blue Connected to Wi-Fi.
Operating Status
Blinking Blue
Out of Water: Ready to submerge, start cleaning.
In Water: End of cycle. Waiting for removal from pool.
Blinking Red Error. See app or troubleshooting.
Floor, walls, and waterline
(2 h 30 min)
Additional cleaning modes available in app. If app mode
chosen, both lights are illuminated.
Floor only (1 h 30 min)
The Cleaner goes into deep sleep after 8 days of inactivity to protect the battery. When all indicators are
off, the cleaner is in sleep mode. Re-set the cleaner on the charging base to wake it up. If this does not
work, see troubleshooting.
3.4 Charging Caddy Status
Solid Green Base is receiving power
Solid Red Charging is in progress
Blinking Green
Charging caddy needs
to be replaced
Figure 5. Charging Caddy Status LED
3.5 Remote Control Status
Remote Blinking
Possible
Cause
Solutions
Remote
Battery
Power is
Low
Remove
battery cover
and replace
both AA
batteries.
NOTE: To replace batteries, use Phillips head
screwdriver to remove 6 screws and replace
batteries. Securely tighten screws after
replacement to ensure remote is watertight.
To Next Page
Loading...
Need help?
General
