93
OPERATION
Track Warm-Up
Follow these steps to ensure proper
warm-up of the engine, drive train
and track.
1. Use an appropriate stand to
securely support the rear of the
snowmobile at the rear
bumper. The track should be
approximately 4" (10 cm) off
the ground.
2. Start the engine and allow it to
warm up two to three minutes.
3. Depress the throttle abruptly and allow the track to rotate several
revolutions.
NOTE: It will take longer to warm up the track sufficiently during colder out-
door temperatures.
4. Release the throttle, apply the brakes, shut off the engine and lower
the snowmobile to the ground.
5. Grasp the skis by their front loops and move them from side to side
to loosen snow and ice.
To Next Page
Loading...
Need help?
General
