83
OPERATION
Electronic Reverse (PERC 4t)
Disengaging Reverse
1. Stop the snowmobile and leave the engine idling.
2. Push the yellow reverse button for one second and release. The light
on the instrument panel will shut off.
3. Apply the throttle slowly to make sure the snowmobile is in for-
ward.
n Emergency Stopping
The following chart lists methods for stopping the snowmobile in the
event of an emergency. See page 80 for more information about the
engine stop switch.
Daily Storage
At the end of each ride, park the snowmobile on a
level surface and support it at the rear with an appro-
priate track stand. The track should be suspended
approximately 4" (10 cm) off the ground.
Remove the key and cover the snowmobile.
SYSTEM WHAT IT DOES
THROTTLE
CONDITION
Ignition Switch Interrupts ignition circuit All
Brake Slows jackshaft All
Engine Stop Switch Interrupts ignition circuit All
To Next Page
Loading...
