7
2.3 I Adjus ng the lead hose
2.3.1 Measuring and cu ng the lead hose
• Measure the deepest point of the pool (for example : 1.80 meters).
• Lay out the leader hose sec on (labelled ) beside the pool.
• The length of the lead hose must be equal to the maximum pool depth.
• Unwind the tape measure beside the hose and begin measurement from the end of the hose containing the back-up
valve ( ).
• Measure to the pool depth previously (i.e. 1.80 metres in the example) measured and mark the hose (
).
• Cut the hose at the marking. Set any excess hose aside ( ).
Recommended
For example:
1.80 meters
2.3.2 Adjus ng lead hose's oats
• Place each oat at a distance of 60 to 90 cm.
• Slide the oats on the hose to posi on them.
To Next Page
Loading...
Need help?
General
