124
Maintenance
Battery
Battery Installation and Connections
1. Set the battery in its holder.
2. Connect and tighten the red (positive) cable first.
3. Connect and tighten the black (negative) cable last.
4. Attach the hold-down s trap.
5. Verify that cables are properly routed.
NOTE: When installing a new battery, make sure it’s fully charged prior to its initial use.
Using a new battery that has not been fully charged can damage the battery and result in a
shorter life. It can also hinder vehicle performance. If recharging is necessary, use a .5
amp battery charger.
Battery Storage
When the vehicle is placed in storage for three months or more, the battery should be
removed, stored out of the sun in a cool, dry place and tested monthly. B efore reusing, take
the battery to your dealer for testing and recharging on a .5 amp battery charger.
To Next Page
Loading...
Need help?
General
