90
Features and Controls
Kick-Start Lever
If the battery becomes too weak to start the engine, the
kick-start lever will allow you to start t he engine until the
battery is serviced. B e sure t he ATV is on a level surface
with the parking brake locked.
1. Fold out the kick-start lever (A) on the lefthand side of
the ATV.
2. Make sure the stop switch i s in the RUN position and
turn the key to ON.
3. Place your foot on the kick-start, and then thrust your
heel downward to crank the engine.
4. After t he engine has started, fold t he kick-start lever back
into place. NOTE: A 10/12mm wrench i s provided in
the t ool kit for removing or installing the lever. If not
installed, make sure the rubber cap is installed on the kick-start shaft to protect the
rider. On 50cc models, store the kick-start lever under the seat (B) when it’s not
installed on the ATV.
A
B
To Next Page
Loading...
