Instr 9927473 Rev 01 2016-12 Page 5 of 13
6. Remove the center console
K
by removing two
screws
L
and five push darts
M
.
7. Remove the plastic winch cover
N
by removing
two screws
P
. Discard the plastic winch cover and
screws.
8. Disconnect the headlight connectors
Q
on both
sides of vehicle.
9. Remove front fascia
R
by removing six screws
S
supporting to radiator shroud and ten screws
T
supporting to chassis and body panels.
POWER CABLES KIT INSTALLATION
1. Route the power kit cables (red and black)
2#
from
battery to bus bar terminals following main wire
harness as shown. Do not connect power cables
to battery and bus bar terminals at this time.
To Next Page
Loading...
