Instr 9927473 Rev 01 2016-12 Page 6 of 13
2. Install red and black cables from power cable kit
2#
to vehicle bus bar as shown.
WINCH INSTALLATION
1. Align and install winch mounting bracket
d
to
chassis bracket
U
and front suspension bracket
V
using four screws
2)
and nuts
2!
and torque to
specification.
TORQUE
20ft. lbs. (27.1 Nm)
2. Connect blue
w
and yellow
q
cables to their
corresponding color terminals on winch assembly
t
as shown. Torque to specification.
TORQUE
4ft. lbs. (5.4 Nm)
3. Slide winch assembly
t
from left to right and
install onto the mounting bracket
d
by aligning
holes and installing screws
l
from the bottom of
the bracket as shown. Torque to specification.
TORQUE
20ft. lbs. (27.1 Nm)
4. Install the autostop fairlead
s
to the fairlead
mounting bracket
f
using two screws
h
. Torque
to specification.
To Next Page
Loading...
