35
Push the button on the control unit, this causes timer illumination on the display. "Hour" indicator light
is flashing on the display. Use or buttons to set a desirable time, and
or buttons to switch over from hours to minutes and vice versa. To save the adjustments, push the
button on the control panel. This causes uttering a beep meaning that the adjustments have been saved.
(Fig. 15)
Setting the cleanup start time.
Push the button on the control unit, this causes timer illumination on the display. "Hour" indicator light
is flashing on the display. Use or buttons to set a desirable time, and or buttons to switch over
from hours to minutes and vice versa. To save the adjustments, push the button on the control panel.
This causes uttering a beep meaning that the adjustments have been saved.
To reset parameters, push and hold down the button for 4 seconds. Once the adjustments are saved,
the device utters a transient beep.
Replacement of power supply elements causes resetting of parameters. Therefore, remember to re-adjust
the time after electric battery replacement.
ACCUMULATOR CHARGING
1.
During use of the charging base, the necessity of charging the accumulator and the charging base location
is automatically determined by the device. The I/O switch on the device body shall be in the "I" position.
Place the charging base right against the wall beside a power outlet in a room to be cleaned, insert the
adapter plug into the outlet. This causes illumination of the signal indicator on the base.
There shall be no obstacles at a distance of 1 meter from two lateral sides, and at a distance of 2 meters from
the front side of the charging base. At the base location area, there shall also be no mirrors and intensively
reflecting surfaces within 15 cm heightwise from the floor. In case of presence of such surfaces, they shall be
blanketed.
Do not place the base against a window if exposure to direct solar radiation is possible. (Fig. 16)
To start charging, move the power switch to the ON position, and put the vacuum cleaner on the base. Make
sure that contact leads on the base align with contact leas on the device.
Under charging/ Low-charged battery
Fully charged / under the cleanup mode
Blue, steady illumination
Turned off / under Sleep mode/ charged a long ago
Do not leave the adapter unattended if energized after charging.
Do not leave the charging base on the floor for long when not in operation.
ACCUMULATOR REPLACEMENT (Fig. 17)
1. Turn off the device through the power switch.
2. Position the device so that its bottom panel faced upward.
3. Use a cross screwdriver (beyond the delivery set) to unscrew the screws of the battery compartment lid, and
remove the lid by prying it up from the screws location side.
4. Take out the depleted accumulator from its compartment, and disconnect its socket by pressing the power
socket latch on the vacuum cleaner, and pulling out the accumulator plug. To connect a new accumulator,
To Next Page
Loading...
Need help?
General
