EasyManua.ls Logo

Polaris RANGER 1000 2020 - Page 48

Polaris RANGER 1000 2020
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SEATING - LE MODELS
SEAT REMOVAL
To remove the driver’s seat, lift up on the rear of the seat and rotate the seat
base up and forward.
To put the passenger seat into the upright position, lift up on the front of the seat
and raise it to the upright position.
SEAT BELTS
This vehicle is equipped with three-point lap and diagonal seat belts for the
operator and passengers. Always make sure the seat belts are secured for all
riders before operating. The driver’s seat belt is equipped with a seat belt
interlock. Vehicle speed will be limited to 15 MPH (24 km/h) if the seat belt is not
secured.
WARNING
Falling from a moving vehicle could result in serious injury or death. Always
fasten your seat belt securely before operating or riding in the vehicle.
To wear the seat belt properly, follow this procedure:
1. For 3-point belts, pull the seat belt latch
q
downward and across your chest
toward the buckle at the inner edge of the seat. The belt should fit snugly
across your hips and diagonally across your chest. Make sure the belt is not
twisted.
2. Push the latch plate
q
into the buckle
w
until it clicks.
46
FEATURES AND CONTROLS

Table of Contents

Other manuals for Polaris RANGER 1000 2020

Related product manuals